people 250 Manuel atelier : Page 170

          13. FUEL SYSTEM/CARBURETOR/
    FUEL PUMP/ FUEL TANK                                                   PEOPLE 250


                                                   Outlet Tube            Vacuum Tube
 FUEL PUMP INSTALLATION
 Install the fuel pump and secure it with the
 two nuts.
 Connect the fuel pump inlet, outlet and
 vacuum tubes.
 Install the met-in box and carrier.
 Install the body cover, center cover and rear
 fender A.



                                                            Nuts                        Inlet Tube




                                                                                 Outlet Tube
 Measure the fuel pump output.
 Start the engine and disconnect the fuel outlet
 tube and place a clean container under the
 tube to check the fuel output.
 Output: 40cc/1700rpm/10 seconds .




                                                   Fuel Pump                            Container




                                                                          Tank Shield

 FUEL TANK REMOVAL
 Remove the floor board. ( 2-7)
 Remove four nuts at the tank shield and
 remove the tank shield.




                                                                   Nuts




                                                                                          13-20