15. REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER DINK50/125 BRAKE MASTER CYLINDER REMOVAL When removing the brake hose bolt, cover the end of the hose to prevent contamination. Secure the hose to prevent fluid from leaking out. Remove the upper handlebar cover (refer to the "FRAME COVERS REMOVAL/INSTALLATION" section in the chapter 2). Drain the rear brake hydraulic system (refer to the "REAR BRAKE FLUID" section in this chapter). Remove the brake lever pivot bolt (1) and nut (2), then remove the brake lever. Disconnect the brake light switch connectors (3). Remove the brake hose oil bolt (4), sealing washer and brake hose eyelet. Remove the two bolts (5) from the master cylinder holder and remove the master cylinder assembly. 15-12