18. STARTING SYSTEM DINK 50/125 STARTER MOTOR REMOVAL Screws Disconnect the starter motor cable. Remove the two bolts attaching the starter motor and remove the starter motor. The installation sequence is the reverse of removal. Connect the starter motor cable connector Check the O-ring for wear or damage and replace it if necessary. Apply grease to the O-ring and install the starter motor. Tighten the two mounting bolts. Torque: 0.81.2kgf-m The starter motor cable connector must Starter Motor be installed properly. O-ring INSTALLATION Coat a new O-ring with engine oil and install it into the start motor groove. Install the starter motor into the crankcase. Install the two screws and engine ground cable, then tighten the screws securely. Connect the start motor cable to motor terminal with the terminal screw and tighten it securely. 18-8