7. CYLINDER/PISTON DINK 50/125 CYLINDER AND PISTON (DINK 125) REMOVAL Remove the cylinder head (refer to "CYLINDER HEAD" section in the chapter 6). Remove the water hose (1) from the cylinder. Remove the two cylinder bolts/washers (2). Remove the cylinder. Remove the cylinder gasket (4) and dowel pins (3). Clean any gasket material from the cylinder surface. Remove the piston pin clip (6). Place a clean shop towel in the crankcase to keep the piston pin clip from falling into the crankcase. Press the piston pin (5) out of the piston and remove the piston (7). 7-5