7. CYLINDER/PISTON DINK 50/125
Measure the piston O.D.
Take measurement at 4.5mm from the
bottom and 90° to the piston pin hole.
Service Limit: 38.9mm replace if below
4.5mm
Measure the piston-to-piston pin clearance.
Service Limit: 0.02mm replace if over
CYLINDER INSPECTION
Inspect the cylinder bore for wear or damage.
Measure the cylinder I.D. at three levels of
top, middle and bottom at 90° to the piston
pin (in both X and Y directions).
Cylinder I.D.:
Service Limit: 39.1mm replace if over
Measure the cylinder-to-piston clearance.
Service Limit: 0.1mm repair or replace if
over
The true roundness is the difference between
the values measured in X and Y directions.
The cylindricity (difference between the
values measured at the three levels) is subject
to the maximum value calculated.
Service Limits:
True Roundness: 0.05mm repair or replace
if over
Cylindricity: 0.05mm repair or replace if over
7-15
Pièce d'origine service de qualité et livraison rapide 
4.7 / 5