18. STARTING SYSTEM DINK 50/125 STARTER RELAY INSPECTION Release the rubber cap (1) and remove the nut (2), then disconnect the start motor cable. Turn the ignition switch to "ON". Squeeze and hold the brake lever fully then push the starter switch. The coil is normal if the start MAG switch clicks. Release the rubber caps (1) and remove the nuts (2), then disconnect the start motor cable, battery positive cable and harness wire. Disconnect the start MAG switch connector (3) and then remove start MAG. Connect a fully charged 12 V battery positive wire to the relay switch Yellow/Red wire terminal and negative wire to the Green/Yellow wire terminal. There should be continuity between the cable terminals while the battery is connected, and no continuity when the battery is disconnected. 18-6