15. REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER DINK50/125 Rest the brake hose eyelet against the stopper. Install the brake hose eyelet with the oil bolt and new sealing washers. Tighten the oil bolt to the specified torque. Torque: 35 N·m (3.5 kgf·m, 25 lbf·ft) Apply silicone grease to the master piston tip. Install the brake lever. Apply silicone grease to the brake lever pivot bolt sliding surface. Install and tighten the pivot bolt to the specified torque. Torque: 2 N·m (0.2 kgf·m, 1.4 lbf·ft) Install and tighten the pivot nut to the specified torque. Torque: 10 N·m (1 kgf·m, 7.2 lbf·ft) Connect the brake light switch connectors. Fill the reservoir to the upper level and bleed the brake system (refer to the "REAR BRAKE FLUID" section in this chapter). 15-14