4. LUBRICATION SYSTEM DINK 50/125 SERVICE INFORMATION GENERAL INSTRUCTIONS · The maintenance of lubrication system can be performed with the engine installed in the frame. · Drain the coolant before starting any operations. · Use care when removing and installing the oil pump not to allow dust and foreign matters to enter the engine and oil line. · Do not attempt to disassemble the oil pump. The oil pump must be replaced as a set when it reaches its service limit. · After the oil pump is installed, check each part for oil leaks. SPECIFICATIONS Unit: mm (in) Standard Service Limit Inner rotor-to-outer rotor clearance 0.15 (0.006) 0.2 (0.008) Outer rotor-to-pump body clearance 0.150.2 (0.0060.008) 0.25 (0.01) Rotor end-to-pump body clearance 0.040.09 (0.00160.0036) 0.12 (0.0048) ENGINE OIL At disassembly: 1.1 liter (DINK125)0.85 liter (DINK50) Engine Oil Capacity At change: 0.9 liter (DINK125)0.70liter (DINK50) Recommended Oil SAE10W30# API: SG TROUBLESHOOTING Oil level too low Poor lubrication pressure · Natural oil consumption · Oil level too low · Oil leaks · Clogged oil filter or oil passage · Worn piston rings · Faulty oil pump · Worn valve guide · Worn valve guide seal Oil contamination · Oil not changed often enough · Faulty cylinder head gasket · Loose cylinder head bolts 4-3