14.HANDLEBAR/FRONT WHEEL/FRONTBRAKE/ FRONT SHOCK ABSORBER/STEERING STEM DINK 50/125 ASSEMBLY Clean all removed parts. Apply silicon grease to the piston and new oil seals. Lubricate the brake caliper cylinder inside wall with brake fluid. Install the new oil seals. Install the brake caliper piston with grooved side facing out. Install the piston with its outer end protruding 35mm beyond the brake caliper. Wipe off excessive brake fluid with a clean shop towel. Install the pad spring. Apply silicon grease to the boots inside. Install the caliper bracket to the caliper Install the pads and then install the front caliper onto the fork leg (refer to the "FRONT BRAKE PAD" section in this chapter). Rest the brake hose eyelet against the stopper. Install the brake hose eyelet with the oil bolt and new sealing washers. Tighten the oil bolt to the specified torque. Torque: 35 N·m (3.5 kgf·m, 25 lbf·ft) Fill the reservoir to the upper level and bleed the brake system (refer to the "FRONT BRAKE FLUID" section in this chapter). 14-26