mxu 400 Manuel atelier : Page 75

          3. Align the front and rear output flanges with the      5. Connect the stator coil, trigger coil, and gear shift
   drive couplers; then secure with the screws and          position switch connectors; then attach the engine
   tighten to 20 ft-lb.                                     ground cable and starter cable and secure with cap
                                                            screws and nuts. Tighten to 8 ft-lb.




                                                 KC242
                                                                                                            KC228A




                                                                                                                      3


                                                 KC243
4. Install the front and rear V-belt cooling boots and                                                      KC228B
   secure with the existing hardware.                    6. Set the inlet air silencer into the frame; then install
                                                            the exhaust pipe using a new exhaust pipe seal and
                                                            grafoil seal. Tighten the cap screws evenly to 20
                                                            ft-lb and install the muffler retainer springs.




                                                 KC235



                                                                                                             KC237




                                                 KC236



                                                                                                              3-45