3. INSPECTION/ADJUSTMENT DINK50/125 BRAKE FLUID Brake fluid level: With the scooter in an upright position, check the front and rear fluid level. It should be above the lower level mark. If the level is at or below the lower level mark "L", check the brake pads for wear. Worn pads should be replaced. If the pads are not worn, have your brake system inspected for leaks. Front brake The recommended brake fluid is DOT 4 brake fluid from a sealed container, or an equivalent. Other checks: Make sure there are no fluid leaks. Check for deterioration or cracks in the hoses and fittings. BRAKE PAD WEAR Brake pad wear depends upon the severity of Rear brake usage, the type of riding, and road conditions. (Generally, the pads will wear faster on wet DINK 125 and dirty roads.) Inspect the pads at each regular maintenance interval. Front brake Check the cutout in each pad. If either pad is worn to the cutout, replace both pads as a set. See your KYMCO dealer for this service. Rear brake Check the cutout in each pad.(DINK 125) If either pad is worn to the cutout, replace both pads as a set. See your KYMCO dealer for this service. Measure the brake lining thickness.(DINK50) DINK 50 Service Limit: 2.0mm replace if below Keep oil or grease off the brake linings. 3-21