1. Kymco
  2. Manuel atelier
  3. dink 50 125 1 Manuel atelier
  4. Page 309

dink 50 125 1 Manuel atelier : Page 309

Microfiches
Image preview

Page 307

Image preview

Page 308

Image preview
Image preview

Page 310

Image preview

Page 311

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 410 415 420 424 
          13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK                                                      DINK 50/125



                                                       Fuel Pump          Bolts

FUEL PUMP REMOVAL
Remove the met-in box.
Remove the frame body cover.
Remove the rear carrier.
Disconnect the fuel pump inlet, outlet and vacuum
tubes.
Remove the two fuel pump attaching bolts and the
fuel pump.




                                                                       Fuel Tank Tube

                                                       Out Tube
FUEL PUMP INSTALLATION
Install the fuel pump and secure it with the two
bolts.
Connect the fuel pump inlet, outlet and vacuum
tubes.
Install the seat, met-in box and frame center cover.




                                                       Vacuum Tube
                                                         Outlet Tube

Measure the fuel pump output.
Start the engine and disconnect the fuel outlet tube
and place a clean container under the tube to check
the fuel output.
Output: 40cc/1700rpm/10 seconds.




                                                                          Container




                                                                               13-42
 Microfiches.net - Catalogue de pièces détachées de toutes marques