6. CYLINDER HEAD/VALVES People GT 125i CAMSHAFT HOLDER REMOVAL Turn the A.C. Generator Flywheel so that the T mark on the flywheel aligns with the index mark on the crankcase. Hold the round hole on the camshaft gear facing up and location is the top dead center on the compression stroke. Remove the two bolts attaching the tensioner Remove the four cap nuts and cylinder two bolts washers from camshaft holder and cylinder two bolts then remove the cam shaft Bolt. Remove the camshaft gear and holder Bolt. INSTALLATION Install the camshaft gear, Holder bolt and holder washers and nuts. Tighten the four cylinder head nuts to the specified torque. Torque: 0.7~1.1 kgf-m (Holder nuts) 1.0~1.4 kgf-m (Cam shaft set plate) 1.8~2.2 kgf-m (Cylinder head M8 *1.25) · Install the camshaft holder with the "EX" mark face exhaust valve side. · Apply engine oil to the threads of the cylinder head cap nuts. · Diagonally tighten the cylinder head cap nuts in 23 times. 6-5