people gt 125 i Manuel atelier : Page 167

          14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
    BRAKE/FRONT SHOCK ABSORBER/FRONT FORK                                          People GT 125i

 Place the brake master cylinder on the
 handlebar and install the holder with the "up"              "UP" Mark
 mark facing up. Also align the punch mark
 with the holder joint seam.
 First tighten the upper bolt and then tighten
 the lower bolt.
 Torque: 12 N-m
 Install the brake fluid tube with the attaching
 bolt and two sealing washers, then tighten the
 fluid tube bolt.
 Connect the front stop switch wire connector.
 Install the handlebar covers. ( 2-3)
                                                     Bolts
 BRAKE FLUID REFILLING
 Keep the handlebar upright and remove the
 brake reservoir cover and diaphragm.
                                                                             Stop Switch
 Add DOT-4 brake fluid to the brake reservoir.
                                                                             Wire Connector
 · When bleeding, be careful not to allow
     air in the brake reservoir flowing into
     the brake system.
   · When using a brake bleeder, follow the
     manufacturer`s instructions.
   · Never use dirty or unspecified brake
     fluid or mix different brake fluids be-
     cause it will damage the brake system.

 BRAKE FLUID BLEEDING
 Keep the handlebar upright and remove the
 brake reservoir cover and diaphragm. Add                            Washer
 the specified brake fluid to the upper limit.
 · Do not allow dust or water to enter the
     brake system during refilling.
   · When servicing the brake system, use
     towels to cover plastic parts and
     coated surfaces to avoid damage
     caused by splash of brake fluid.
 In order to avoid spilling brake fluid, connect a                       Bleed Valve
 transparent hose to the bleed valve.
   Warning
   Brake fluid spilled on brake pads or
   brake disk will reduce the braking effect.
   Clean the brake pads and brake disk
   with a high quality brake degreaser.
 Fully apply the brake lever and then loosen
 the brake caliper bleed valve to drain the
 brake fluid until there is no air bubbles in the
 brake fluid. Then, tighten the bleed valve.
 Repeat these steps until the brake system is
 free of air.


                                                                                        14-10