MD1060 MD1017 4. Place the pin into position on the oil pump shaft, install the oil pump driven gear making sure the recessed side of the gear is directed inward, and secure with a new snap ring. NOTE: Always use a new snap ring when install- ing the oil pump driven gear. MD1018 7. Install the clutch shoe assembly on the crankshaft; then install the flange nut (left-hand thread) (coated with red Loctite #271). Tighten to 147 ft-lb. NOTE: The flat side of the flange nut should be directed towards the clutch shoe. MD1020 ! CAUTION Care must be taken when installing the flange nut; it has "left-hand" threads. 8. Install the one-way clutch making sure that the green dot or the word OUTSIDE is directed away from the crankcase. MD1019 5. Install the cam chain. NOTE: Keep tension on the cam chain to avoid damaging the crankcase boss. 6. Place the pin into position, install the oil pump drive gear, and tighten the cap screw (coated with red Loctite #271) to 63 ft-lb. MD1286 9. Install gear shift position switch spacer and switch making sure to align the drive pin with the slot in the shift shaft. 3-34