MD1034 MD1068 8. Using an impact screwdriver, remove the three Phillips-head cap screws holding the air intake plate. Remove the air intake plate. MD1036 5. Remove the V-belt. MD1092 9. Remove the cap screws holding the clutch cover onto the right-side crankcase half. Note the posi- tions of the different-lengthed cap screws for installing purposes. 10. Using a rubber mallet, loosen the clutch cover; then pull it away from the right-side crankcase half. Account for two alignment pins and gasket. MD1118 6. Remove the fixed drive face. MD1115 D. Gear Shift Position Switch E. Centrifugal Clutch Assembly F. Oil Pump Drive Gear MD1094 G. Oil Pump Driven Gear 7. Remove the nut holding the driven pulley assem- bly; then remove the driven pulley assembly. NOTE: Steps 1-10 in the preceding sub-section must precede this procedure. 3-30