4. Install the cam stopper assembly. 5. Install the gear shift shaft assembly and washer making sure to align the alignment marks. MD1122 Installing Left-Side MD1239 Components 6. Install starter idler gear (No. 2) and starter idler gear (No. 1). A. Starter Idler Gears B. Rotor/Flywheel 1. Place the crankshaft bearing retainer into position. Apply red Loctite #271 to the three cap screws. Install and tighten the three cap screws securely. MD1305 7. Place the key into its notch; then slide the rotor/ flywheel (with the ring gear in place) over the crankshaft. Tighten the nut to 107 ft-lb. C. Cover NOTE: Steps 1-7 in the preceding sub-section MD1122 must precede this procedure. 2. Install the starter motor and tighten the two cap screws securely. 8. Install two alignment pins and place the left-side cover gasket into position. Install the left-side 3. Install the shift detent cam making sure the spacer cover. Noting the different-lengthed 6 mm cap is properly positioned. screws, the position of the shifter bracket, and the location of the long cap screw with the washer, tighten cap screws in a crisscross pattern to 8 ft-lb. 9. Place the outer magneto cover into position on the left-side cover; then install and tighten the four cap screws securely. MD1086 3-28