KC291A CD106 3. Using a side-cutter (or suitable substitute), remove Disassembling Input Shaft the boot clamps; then remove the boots and splined drive from the input shaft. NOTE: This procedure can be performed on a rear gear case; however, some components may 4. Remove the input shaft from the pinion housing. vary from model to model. The technician should use discretion and sound judgment. 1. Remove the cap screws securing the front drive actuator and remove the actuator; then remove the cap screws securing the pinion housing. CD107 5. Using a seal removal tool, remove the input shaft seal. Account for a spacer. 6 CD102 2. Using a rubber mallet, remove the housing. Account for a gasket. Remove the fork, collar, and spring. Note the location of all the components for assembling purposes. AF982 6. Remove the snap ring securing the input shaft bearing; then place the pinion housing in a press and remove the bearing. CD103 6-5