super 8 50 2t 1 Manuel atelier : Page 46

          3. INSPECTION/ADJUSTMENT                                                         SUPER8 50 2T

                                                                 Filter Screen

 Clean the oil filter screen with compressed
 air.
 Install the oil filter in the reverse order of
 removal and fill the oil tank with specified oil
 up to the proper level.
 Bleed air from the oil pump and oil lines.
· Connect the oil tubes securely.
   · Install the tube clip at the oil tank side
     and also install the clip to the lower oil
     tube that goes to the oil pump.
   · Check for oil leaks.



 Oil Pump Condition
                                                      Lock Nut           Control Lever Aligning Mark
   Adjust oil pump control cable after the
   throttle grip free play is adjusted.

 Open the throttle valve fully and check that
 the index mark on the pump body aligns
 with the aligning mark on the oil pump
 control lever.
 Reference tip alignment within 1mm of
 index mark on open side is acceptable.
 Start and idle the engine, then slowly open
 the throttle to increase engine rpm and
 check the operation of the oil pump control
 lever.
 If adjustment is necessary, adjust the oil
 pump control cable by loosening the control
 cable lock nut and turning the adjusting nut.      Adjusting Nut      Pump Body Index Mark
 After adjustment, tighten the lock nut.
Reference tip alignment within 1mm of
   index mark on open side is acceptable.
   However, the aligning mark on the
   control lever must never be on the
   closed side of the index mark, otherwise
   engine damage will occur because of
   insufficient lubrication.


 If the oil pump is not synchronized properly,
 the following will occur:
 · Excessive white smoke or hard starting
    due to pump control lever excessively
    open
 · Seized piston due to pump control lever
    insufficiently open.


3-11