16. INSTRUMENT/SWITCHES/LIGHTS SUPER8 50 2T Fuel Unit INSTALLATION The installation sequence is the reverse of removal. · Install the fuel unit at the connect position. Wire Connector OIL METER INSPECTION Oil Meter G/R B G Remove the met-in box. ( 12-4) B Remove the frame body cover. ( 12-4) Disconnect the oil meter wire connectors and remove the oil meter. Keep the oil meter float at the lower position. Measure the resistances between the wire terminals as and shown in the left figure. Wire Terminals Resistance Float Green/Red(+)Black(-) 46 Green(-)Black(+) Before removing the oil meter, be sure to drain the motor oil and do not allow sparks or flames near the working area. Oil Meter Operation Inspection Connect the oil meter wire connectors and turn the ignition switch ON. Measure the resistance between the wire terminals with the float at upper position. Light OFF 4.51.0mm Light OFF Green/Red(+)Black(-) About 300 Light ON Before performing the following test, operate the turn signals to determine that the battery circuit is normal. 16-3