13. BRAKE SYSTEM MXU 250R/300R
ASSEMBLY (MXU 250)
Reassemble the caliper in the reverse order
of disassembly procedures and observe the
following points.
Wash the caliper components with fresh
brake fluid before assembly. Do not
wipe off brake fluid after washing the
components.
Replace the piston seal and dust seal
with new ones with brake fluid applied.
Brake fluid specification and
classification: DOT4
Fit the O-rings. O-rings
Install and tighten the caliper housing bolts.
Torque: 2.2 kgf-m (22 Nm, 16 lbf-ft)
INSTALLATION (MXU 250) Washers
Install the rear caliper and tighten the two
mounting bolts.
Torque:
Brake caliper mounting bolt (replace a
new one): 3.2 kgf-m (32 Nm, 25 lbf-ft)
With the tube ends contacted to the caliper
and install the washers and tighten the fluid
tube bolts.
Washers
Torque: 3.5 kgf-m (35 Nm, 25 lbf-ft)
Fill the system with brake fluid and bleed
air. (page 13-13)
13-21
4.7 / 5