9. CLUTCH/GEAR SHIFT MECHANISM Pulsar CK 125 Install the set pin into the transmission drum hole. Install the gear shift cam, aligning the pin hole in the gear shift cam with the set pin. Then, tighten the bolt. Torque: 0.81.2kg-m · After the gear shift cam is installed, put the stopper in the gear shift cam groove and tighten the stopper bolt. · Rotate the transmission drum to make sure that the stopper operates properly. Set pin Install the gear shift spindle and washer. During installation, make sure that the return spring aligns with the crankcase tab. Gear Shift Spindle Return Spring Thrust Washer Install the clutch outer and thrust washer. Install the thrust washer with the chamfered side facing up. Install the clutch assembly. Stagger the clutch friction disks and clutch plates and then put them on the clutch center. Then install the clutch center together with the well-arranged friction disks and plates into the clutch outer. Install the circlip. Install the circlip with the chamfered side facing down. 20mm Circlip 9-7