8. STARTER MOTOR/GENERATOR/LEFT CRANK- CASE COVER/STARTER CLUTCH/CAMSHAFT Pulsar CK 125 STARTER MOTOR REMOVAL Remove the two starter motor mounting bolts and the motor. Inspect the starter motor O-ring for damage or deterioration. Inspect the starter motor pinion for wear or damage. Mounting Bolts Bolts Shaft Reduction Gear O-ring Remove the three bolts attaching the starter motor reduction gear cover. Remove the reduction gear cover. Remove the reduction gear, shaft and washers. Inspect the reduction gear for wear or damage. Inspect the reduction gear cover O-ring for damage or deterioration. Reduction Gear Cover Pin Washers Cover Reduction Pinion LEFT CRANKCASE COVER/ GENERATOR REMOVAL Disconnect the neutral light switch wire. Remove the eight left crankcase cover bolts. Remove the left crankcase cover and two dowel pins. Clean off all gasket material from the left crankcase cover. Remove the reduction pinion. Bolts Washers Neutral Light Wire Flywheel Lock Bolt Flywheel Puller Hold the flywheel with a flywheel holder. Remove the flywheel lock bolt. Remove the flywheel using a flywheel puller. Flywheel Holder Flywheel Holder Flywheel 8-2