4. FUEL SYSTEM Pulsar CK 125 Groove Install the throttle valve into the carburetor body. Align the groove in the throttle valve with the throttle stop screw on the carburetor body. Connect the accelerating pump cable. Fully open the throttle and adjust the accelerating pump cable to align the punch mark on the accelerating pump arm with the punch mark on the set plate. Throttle Stop Screw Carburetor Cap Tighten the carburetor cap. Inspect the throttle grip free play and adjust if necessary. Throttle Grip Free Play: 26mm FUEL TANK/FUEL VALVE FUEL TANK REMOVAL Warning · Keep sparks and flames away from the work area. · Wipe off any spilled gasoline. Remove the right and side covers. Remove the two lock nuts attaching the seat and remove the seat. Lock Bolt Switch the fuel valve "OFF". Disconnect the fuel tube and remove the bolt on the end of the fuel tank. Disconnect the fuel unit wire connector. Remove the fuel tank. Fuel Unit Wire Connector 4-8