new pulsar 125 Manuel atelier : Page 47

          4. FUEL SYSTEM                                                                Pulsar      CK   125


 SLOW/MAIN JET INSTALLATION                       Throttle Stop Screw               Slow Jet
 Install the slow jet.
 Install the needle jet and main jet.
 Install the throttle stop screw and air screw.

 · When installing the air screw, return it
      to the original position as noted during
      removal
    · After the carburetor is installed, be
      sure to perform the Exhaust Emission

                                                          Air Screw                   Main Jet



                                                       Float
 Install the float valve, float and float pin.




                                                                              Float Pin


 FLOAT LEVEL INSPECTION
 Turn the carburetor upside down so that the
 float will go down to make the float valve
 contact the float valve seat.
 Then slowly tilt the carburetor and measure
 the float level with the float level gauge
 while the float pin just contacts with float
 valve.

 Float Level: 12.5mm                                                    Float Level Gauge
 When adjusting, carefully bend the float pin.
 Check the float for proper operation and then
 install the float chamber.




                                                                                                4-6