14.STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK LIKE 200i HYDRAULIC BRAKE (FRONT BRAKE) BRAKE FLUID REPLACEMENT/AIR BLEEDING Check the brake fluid level on level ground. · When operating the brake lever, the Lower Limit brake reservoir cap must be tightened securely to avoid splash of brake fluid. · When servicing the brake system, use shop towels to cover plastic parts and coated surfaces to avoid damage caused by splash of brake fluid. Hose BRAKE FLUID BLEEDING In order to avoid spilling brake fluid, connect a transparent hose to the bleed valve. Warning Spilled brake fluid on brake pads or brake disk reduces stopping power. Clean the brake pads and brake disk with a high-performance brake d Fully apply the brake lever and then loosen the brake caliper bleed valve to drain the Front Brake Caliper brake fluid until there is no air bubbles in the Reservoir brake fluid. Then, tighten the bleed valve. Repeat these steps until the brake system is free of air. BRAKE FLUID REFILLING Add DOT-3 brake fluid to the brake reservoir. · When bleeding, be careful not to allow air in the brake reservoir flowing into the brake system. · Never use dirty or unspecified brake fluid or mix different brake fluids be- cause it will damage the brake system. Fixed-Reed Make sure to bleed air from the brake system. BRAKE PAD/DISK REPLACEMENT The brake pads must be replaced as a set to ensure the balance of the brake Remove the two bolts attaching the brake caliper. Remove the brake caliper. Compress the brake caliper seat, and press down the fixed-reed to take out the brake pads. 8