12. FUEL SYSTEM LIKE 200i ECU Module Replacement When switch is on and battery is connected, don't remove ECU module, connect additional wire or cut any wire. 1.Make sure to replace the ECU module after the ignition switch is turned off. 2.To identify if new ECU with certain version, check with sticker on ECU or with diagnostic tool. 3.To aim the axle of throttle at knob of TPS then assemble the ECU module and install to vehicle. 4.After assembling ECU module, to confirm if operating throttle smoothly and throttle back in position precisely when release acceleration. 5.Proceeding TPS initial and adaptation setting after replacing the ECU module would be necessary. 6.Connecting diagnostic tool to the diagnostic connector, to check if throttle position and output voltage from TPS are out of the range. Item Specification TPS Idle (0°)=0.230.05V voltage Throttle fully(>90°) = over3.27V 7.To run the engine till reaching the working temperature and check with diagnostic tool and refer to the related diagnostic report, to confirm all figures are fitted in standard. (Especially notice if there is any abnormal leaking symptom or unstable situation at idle speed) 12-11