1. GENERAL INFORMATION Pulsar CK 125 TROUBLESHOOTING ENGINE WILL NOT START OR IS HARD TO START Inspection/Adjustment Symptom Probable Cause Check if fuel reaches carburetor by loosening drain screw Empty fuel tank Clogged fuel line between fuel tank and carburetor Clogged float valve Fuel reaches Fuel does not Clogged fuel filter carburetor reach carburetor Clogged fuel tank cap breather hole Clogged auto fuel valve strainer Remove spark plug and Clogged fuel valve passage install it into spark plug Clogged carburetor air balance cap to test spark by tube making it contact the engine Faulty spark plug Fouled spark plug Faulty CDI unit Spark jumps Weak or no spark Faulty pulser coil Faulty exciter coil Faulty ignition switch Broken or shorted ignition coil wire Test cylinder compression Faulty or slipping clutch Valve clearance too small Normal Low or no Valve stuck open compression compression Worn cylinder and piston rings Leaking cylinder head gasket Start engine by follow- ing normal starting procedure Faulty choke control system Engine does not Engine fires but Leaking intake manifold fire does not start Incorrect ignition timing Incorrectly adjusted air screw Remove spark plug and inspect again Flooded carburetor Dry spark plug Wet spark plug Throttle valve excessively open Clogged air cleaner 1-16