11. FRONT WHEEL/SUSPENSION/ STEERING Pulsar CK 125 FRONT WHEEL REMOVAL Place a jack or other adjustable support under the engine to raise the front wheel off the ground. Remove the speedometer cable set screw and disconnect the speedometer cable. Remove the front axle nut and pull out the axle. Remove the front wheel. Axle Screw Speedometer Cable INSPECTION Set the axle in V blocks and measure the runout using a dial gauge. Service Limit: 0.2mm replace if over WHEEL RIM INSPECTION Place the front wheel in a turning stand. Spin the wheel by hand and measure the rim runout using a dial gauge. Service Limits: Axial : 2.0mm adjust if over Radial : 2.0mm adjust if over Check the wheel spoke wires for looseness. If the wheel rim is made of aluminum alloy, replace with a new one if necessary. Check the wheel bearing play by placing the wheel in a turning stand and spinning the wheel by hand. Replace the bearings with new ones if they are noisy or have excessive play. Radial Axial 11-6