like 200 i Manuel atelier : Page 76

          8. A.C. GENERATOR                                                               LIKE 200i

                                                                    Wire Set Plate

Remove the A.C. generator wire connector.




                                                              Bolts
                                                           Stator
Remove the A.C. generator wire set plate.
Remove the pulser coil bolts.
Remove the A.C. generator wire rubber sleeve
and Crankshaft Position Sensor from the right
crankcase.
Remove the two bolts and A.C. generator stator.



                                                         CPS Set Plate
                                                     Woodruff Key
INSTALLATION
Install the A.C. generator stator and Crankshaft
Position Sensor onto the right crankcase.
Tighten the stator and CPS bolts.

Torques: CPS          0.5kg-m
            Stator     0.9kg-m


Install the A.C. generator wire rubber sleeve and
A.C. generator wire set plate.


Connect the A.C. generator wire connector.
Clean the taper hole in the flywheel off any burrs
and dirt.
Install the woodruff key in the crankshaft
keyway.




                                                                                     7-4