12. CARBURETOR SUPER 9 50 CARBURETOR INSTALLATION O-rings When installation, do not allow foreign particles to enter the carburetor. Check the carburetor insulator and O-ring for wear or damage. Install the carburetor and insulator onto the intake manifold and tighten the two lock nuts. Connect the fuel tube and auto bystarter wire connector. Route the auto bystarter wire correctly and properly. Install the carburetor cap. ( 12-4) Insulator Install the air cleaner onto the carburetor and tighten the band screw. Carburetor Cap Band Install the met-in box. ( 2-3) AIR SCREW ADJUSTMENT Remove the met-in box. ( 2-3) Warm up the engine before air screw adjustment. Turn the air screw clockwise until it seats lightly and back it to the specification given. Air Screw Opening: SH10DA: 1 turns Start the engine and turn the air screw in or Fuel Tube out slowly to obtain the highest engine speed. Air Screw Do not force the air screw against its seat to prevent damage. Turn the throttle stop screw to obtain the specified idle speed. Idle Speed: SH10DA: 2000100rpm Slightly increase the engine speed and make sure that the engine does not miss or run erratic. If the adjustment of the air screw within the range of turn makes no difference to the engine performance, check other related items. Throttle Stop Screw 12-10