1. Kymco
  2. Manuel atelier
  3. mxu 550 exi Manuel atelier
  4. Page 256

mxu 550 exi Manuel atelier : Page 256

Microfiches
Image preview

Page 254

Image preview

Page 255

Image preview
Image preview

Page 257

Image preview

Page 258

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 410 415 420 422 
          11.FINAL REDUCTION/
   TRANSMISSION SYSTEM                                             MXU 550EXi/MXU500i



 Install and tighten the nut to the specified
 torque by using the special tool.

 Torque: 11 kgf-m (110 N-m)

 Special tool:
 Nut wrench                 A120E00066

 Apply clean engine oil to the new oil seal lip
 then install the oil seal.

                                                  Oil Seal               Nut




 FRONT SIDE BEARING

 Remove the oil seal.

 Remove the snap ring.




                                                  Oil Seal                Snap Ring




 Remove the bearing by using the special tool.

 Special tool:
 Bearing Puller             A120E00037

 Install the new bearing by using the special
 tool.

 Special tool:
 Bearing driver             A120E00014            Bearing Puller         Bearing Driver


11-15
 Microfiches.net - Catalogue de pièces détachées de toutes marques