mxu 500 irs 1 Manuel atelier : Page 114

Microfiches
Image preview

Page 112

Image preview

Page 113

Image preview

Page 115

Image preview

Page 116

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 407
          6. COOLING SYSTEM                                                                    MXU 500 IRS


 SERVICE INFORMATION

 GENERAL INSTRUCTIONS

 WARING:
 Removing the radiator cap while the engine is hot can allow the coolant to spray out,
 seriously scalding you. Always let the engine and radiator cool down before removing the
 radiator cap.

 CAUTION:
 Radiator coolant is toxic. Keep it away from eyes, mouth, skin and clothes.

 · If any coolant gets in your eyes, rinse them with water and consult a physician immediately.
 · If any coolant in swallowed, induce vomiting, gargle and consult a physician immediately.
 · If any coolant gets on your skin or clothes, rinse thoroughly with plenty of water.

 NOTE:
   Use coolant with silicate inhibitors may cause premature wear of water pump seals or blockage
   of radiator passages. Using tap water may cause engine damage.

 · This section covers service of the cooling system.
 · Add coolant at the reserve tank. Do not remove the radiator cap except to refill or drain the
   system.
 · All cooling system services can be done with the engine in the frame.
 · Avoid spilling coolant on painted surfaces.
 · After servicing the system, check for leaks with a cooling system tester.




 SPECIFICATIONS
                       ITEM                                       SPECIFICATIONS
 Coolant capacity           Radiator and engine    2 liter (2.1 US qt, 1.76 lmp qt)
                               Reserve tank        0.45 liter (0.47 US qt, 0.39 lmp qt)
 Radiator cap relief pressure                      90 kPa (0.9 kgf/cm2, 12.8 psi)
                          Begin to open            80 - 84°C (176 - 183°F)
 Thermostat               Fully open               95°C (203°F)
                          Valve lift               8 mm (0.3 in) minimum
 Standard coolant concentration                    1:1 mixture with soft water




                                                                                                   6-2