agility 50 city 2t Manuel atelier : Page 162

          16. INSTRUMENT/SWITCHES/LIGHTS                                             AGILITY CITY 50 2T
                                                               Fuel Unit

 INSTALLATION
 The installation sequence is the reverse of
 removal.
 · Install   the fuel unit at the connect
     position.
 OIL METER
 INSPECTION
 Remove the met-in box. ( 12-4)
 Remove the frame body cover. ( 12-4)                          Wire Connector
 Disconnect the oil meter wire connectors
 and remove the oil meter. Keep the oil
 meter float at the lower position.                Oil Meter                            B
 Measure the resistances between the wire                             G/R           G
 terminals as      and      shown in the left                               B
 figure.

      Wire Terminals            Resistance
  Green/Red(+)Black(-)              46
    Green(-)Black(+)                 

 Before removing the oil meter, be sure
   to drain the motor oil and do not allow             Float
   sparks or flames near the working area.

 Oil Meter Operation Inspection
 Connect the oil meter wire connectors and
 turn the ignition switch ON.
 Measure the resistance between the wire
 terminals with the float at upper position.

  Green/Red(+)Black(-)         About 300                              Light OFF
                                                                                  4.51.0mm
                                                                            Light OFF
 Before     performing the following test,                           Light ON
   operate the turn signals to determine
   that the battery circuit is normal.



 Move the oil meter float up and down to see                                                 Oil Indicator
                                                                                                 Light
 if the oil indicator light will go out and come
 on.
 If the  oil indicator light does not light,
   check for burned bulb, loose wire or
   connector. After correction, check again
   according to the method mentioned
   above.

16-3