13. STEERINGHANDLEBAR/FRONTWHEEL/FRONT BRAKE/FRONTSHOCKABSORBER/FRONTFORK INSPECTION Measure the brake master cylinder I.D. Inspect the master cylinder for scratches or cracks. Service Limit: 12.75mm Measure the brake master cylinder piston O.D. Service Limit: 12.645mm Before assembly, inspect the lst and 2nd rubber cups for wear. ASSEMBLY Before assembly, apply brake fluid to all Master Cylinder Spring Main Piston removed parts. Install the spring together with the 1st rubber cup. · During assembly, the main piston and spring must be installed as a unit without exchange. · When assembling the piston, soak the cups in brake fluid for a while. · Install the cups with the cup lips facing the correct direction. Washer Snap Ring Rubber Cover Install the main piston, spring and snap ring. Install the rubber cover. Fluid Tube Bolt Punch Mark Install the brake lever. Place the brake master cylinder on the handlebar and install the holder with the "up" mark facing up. Also align the punch mark with the holder joint seam. First tighten the upper bolt and then tighten the lower bolt. Torque: 1.01.4kg-m Install the brake fluid tube with the attaching bolt and two sealing washers. "Up" Mark 13-9