3.INSPECTION/ADJUSTMENT Clean the oil filter screen with compressed air. Install the oil filter in the reverse order of removal and fill the oil tank with specified oil up to the proper level. Bleed air from the oil pump and oil lines. · Connect the oil tubes securely. · Install the tube clip at the oil tank side and also install the clip to the lower oil tube that goes to the oil pump. · Check for oil leaks. Filter Screen Oil Pump Condition Control Lever Aligning Mark Adjust oil pump control cable after the throttle grip free play is adjusted. Open the throttle valve fully and check that the index mark on the pump body aligns with the aligning mark on the oil pump control lever. Reference tip alignment within 1mm of index mark on open side is acceptable. Start and idle the engine, then slowly open the throttle to increase engine rpm and check the operation of the oil pump control lever. If adjustment is necessary, adjust the oil pump control cable by loosening the control Pump Body Index Mark Lock Nut Adjusting Nut cable lock nut and turning the adjusting nut. After adjustment, tighten the lock nut. Reference tip alignment within 1mm of index mark on open side is acceptable. However, the aligning mark on the control lever must never be on the closed side of the index mark, otherwise engine damage will occur because of insufficient lubrication. If the oil pump is not synchronized properly, the following will occur: · Excessive white smoke or hard starting due to pump control lever excessively open · Seized piston due to pump control lever insufficiently open 3-11