3. INSPECTION/ADJUSTMENT ATV 150/125 GEAR OIL CHANGE Remove the oil filler bolt. Removes the oil drains bolt and drain the oil thoroughly. Install the oil drain bolt. Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft) Make sure that the sealing washer is in good condition. Fill with the recommended oil. Oil Capacity: At disassembly: Oil Drain Bolt/ Sealing Washer 400 cc (0.352 lmp qt, 0.424 US qt) At change: 200 cc (0.176 lmp qt, 0.212 US qt) Reinstall the oil filler bolt and check for oil leaks. Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft) DRIVE BELT Remove the left crankcase cover. Inspect the drive belt for cracks, scaling, chipping or excessive wear. Drive Belt Measure the V-belt width Service limit: 17 mm (0.68 in) Wear Indicator Replace the drive belt if out of specification. BRAKE SHOE Replace the brake shoes if the arrow on the wear indicator plate aligns with the punch mark on the brake panel when the brake is fully applied. Punch Mark BRAKE SYSTEM FRONT BRAKE Measure the front brake lever free play. Free Play: 1020 mm (0.40.8 in) Adjust if out of specification. 3-9