16. INSTRUMENT/SWITCHES/LIGHTS AGILITY RS 50 NAKED INSTALLATION The installation sequence is the reverse of removal. Fuel Unit · Install the fuel unit at the connect position. OIL METER INSPECTION Remove the met-in box. ( 12-4) Remove the frame body cover. ( 12-4) Disconnect the oil meter wire connectors and remove the oil meter. Keep the oil Wire Connector meter float at the lower position. Measure the resistances between the wire terminals as and shown in the left figure. Oil Meter G/R G Wire Terminals Resistance B B Green/Red(+)Black(-) 46 Green(-)Black(+) Before removing the oil meter, be sure to drain the motor oil and do not allow Float sparks or flames near the working area. Oil Meter Operation Inspection Connect the oil meter wire connectors and turn the ignition switch ON. Measure the resistance between the wire terminals with the float at upper position. Green/Red(+)Black(-) About 300 Light Light OFF Before performing the following test, Light ON 4.5 operate the turn signals to determine that the battery circuit is normal. Move the oil meter float up and down to see Oil Indicator if the oil indicator light will go out and come Light on. If the oil indicator light does not light, check for burned bulb, loose wire or connector. After correction, check again according to the method mentioned above. 16-3