16. BRAKE SYSTEM MXU 550EXi/MXU 500i Parking Brake Cable REAR BRAKE/PARKING BRAKE CALIPER REMOVAL/INSTALLATION Drain the brake fluid from the hydraulic brake system (refer to the "COMBINATION BRAKE FLUID CHANGE/AIR BLEED section in this chapter). Disconnect the parking brake cable from the caliper. Remove the brake fluid hose bolt and two washers from the caliper. Remove the brake pads (refer to the "BRAKE PADS REPLACEMENT" section in this chapter). Remove the brake caliper. INSTALLATION Install the brake fluid hose with the attaching bolt and two new sealing washers, then tighten the bolt to the specified torque. Torque: 3.5 kgf-m (35 Nm, 25 lbf-ft) Connect the parking brake cable. Fill the specified brake fluid and bleed air from the brake system (refer to the "COMBINATION BRAKE FLUID CHANGE/AIR BLEED section in this chapter). Adjust the parking brake lever (refer to the "PARKING BRAKE ADJUSTMENT" section in the chapter 3). 16-36