stryker 125 Manuel atelier : Page 128

          10.CRANKCASE/CRANKSHAFT/TRANS-
   MISSION SYSTEM/STARTER SPINDLE                                         STRYKER 125/150
                    Bearings



                                                                         Right Crankcase
 INSTALLATION
 Install the starter spindle onto the right
 crankcase.
 When installing the starter spindle, be
    sure to insert the return spring end into
    the crankcase hole.

 Install the washer.


                                                  Starter Pawl
                                                                 Main Shaft           Countershaft
 First assemble the main shaft and
 countershaft and then install them into the
 right crankcase.
 When assembling the main shaft and
    countershaft, be sure to install all of the
    washers.

 Install the balance shaft.
 Install the transmission drum

                                                                  Transmission Drum    Starter Spindle


 Install the right transmission fork to the
 countershaft 4th gear. Raise the gear and
 install the transmission fork guide pin into
 the transmission drum groove.
 The transmission fork can be installed
    more easily by turning the neutral light
    copper piece on the transmission drum
    toward the cylinder.


                                                  Transmission Drum       Right Transmission Fork

 Then, install the middle transmission fork to
 the main shaft 3rd gear and install the fork
 guide pin into the transmission drum groove.




10-11