1. Kymco
  2. Manuel atelier
  3. mxu 550 exi Manuel atelier
  4. Page 152

mxu 550 exi Manuel atelier : Page 152

Microfiches
Image preview

Page 150

Image preview

Page 151

Image preview
Image preview

Page 153

Image preview

Page 154

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 410 415 420 422 
          7. ENGINE REMOVAL/INSTALLATION                                    MXU550EXi/MXU500i


 ENGINE REMOVAL                                Lower Water Hose                Rubber Band
 Drain engine oil (refer to the "ENGINE
 OIL" section in the chapter 3).
 Remove frame covers and exhaust pipe
 (refer to the "FRAME COVERS" section
 in the chapter 2).
 Drain the engine coolant (refer to the
 "COOLANT REPLACEMENT" section
 in this chapter).
 Remove the air cleaner housing and throttle
 body (refer to section s in the chapter 5).

 Disconnect the lower water hose and bypass
 hose from water pump cover.
 Cut the rubber band off on the water hose.                 Bypass Hose

 Loosen the band screw and remove the two
 mounting bolts from the rear cooling duct,
 then remove the rear cooling duct.
                                                                   Cooling Duct




                                                            Band Screw

                                                          Front Cooling Duct

 Loosen the band screw and remove the
 fastener from the front cooling duct, then
 remove the front cooling duct.




                                                            Band Screw

                                                                                      7-2
 Microfiches.net - Catalogue de pièces détachées de toutes marques