kxr 50 90 2 Manuel atelier : Page 203

          13. REAR WHEEL/SWING ARM/
    HYDRAULIC BRAKE                                               Mongoose/KXR 90/50


 BRAKE SYSTEM BLEEDING
 Connect a transparent hose to the bleed
 valve and fully apply the brake lever after
 continuously pull it several times. Then,
 loosen the bleed valve nut to bleed air from
 the brake system. Repeat these steps until
 the brake system is free of air.

   When bleeding air from the brake system,
   the brake fluid level should be kept over
   1/2 of the brake reservoir height.
                                                Brake Lever            Bleed Valve



 BRAKE PAD/DISK
 BRAKE PAD REPLACEMENT
 Remove the two bolts attaching the brake
 caliper holder.

   The brake pads can be replaced without
   removing the brake fluid tube.

 Remove the brake caliper.
                                                                              Bolts

                                                Brake Caliper Holder
 Push the brake caliper holder and then
 remove brake pad.




                                                                       Brake Bad



 Remove the other brake pad.

 ASSEMBLY
 Assemble the brake pads in the reverse
 order of removal.

   Make sure the pad spring has fitted.


                                                           Brake Bad          Pad Spring



                                                                                      13-16