grand dink 125 mmc Manuel atelier : Page 9

          1. GENERAL INFORMATION                                                 GRAND DINK 125/150
  After clamping, check each wire to make
  sure it is secure.                              Route harnesses so they are neither
                                                  pulled tight nor have excessive slack.
                                                                            Do not pull
                                                                            too tight




  Do not squeeze wires against the weld or
  its clamp.
                                                  Protect wires and harnesses with electrical
                                                  tape or tube if they contact a sharp edge or
                                                  corner.



  After clamping, check each harness to
  make sure that it is not interfering with any
  moving or sliding parts.


                                                  When rubber protecting cover is used to
                                                  protect the wire harnesses, it shall be
                                                  installed securely.



  When fixing the wire harnesses, do not
  make it contact the parts which will
  generate high heat.
                           No Contact
                                                  Do not break the sheath of wire.
                                                  If a wire or harness is with a broken sheath,
                                                  repair by wrapping it with protective tape
                                                  or replace it.


  Route wire harnesses to avoid sharp edges
  or corners. Avoid the projected ends of
  bolts and screws.
  Route wire harnesses passing through the
  side of bolts and screws. Avoid the
  projected ends of bolts and screws.             When installing other parts, do not press or
                                                  squeeze the wires.
                                                                        Do not press or
                                                                        squeeze the wire




                                                                                           1-6