13. FUEL INJECTION SYSTEM Downtown 300i ABS
WTS SENSOR (Water
Temperature Sensor)
REMOVAL / INSTALLATION
Drain the coolant from the cooling system.
Disconnect the WTS sensor connector from
the sensor.
Remove the WTS sensor and O-ring.
Install a new O-ring and WTS sensor.
Always replace an O-ring with a new one.
Tighten the WTS sensor to the specified
torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling system with the
recommended coolant.
O-ring
INSPECTION
Measure the resistance at the WTS sensor
terminals.
STANDARD
C -20 40 100
K 18.8 1.136 0.1553
13-22
RAS 
4.7 / 5