dinkstreet 125 Manuel atelier : Page 178

          14. DOWNTOWN 125 i        FUEL SYSTEM (Auto Control Fuel Injection System)


 CELP Failure Code Chart(2)




   Blink   Failure       Fault description        Priority                   Fault management
            Codes


    5      P1122     Throttle position sensor        2       1.Make sure if the connector of Throttle position sensor is
                                                             connected correctly.
                     movement speed                          2.Check if theThrottle position sensor is adjusted.
                     problem
    6      P0560     Battery voltage                 1       1. Check if the battery voltage is lower or higher.
                     malfunction                             2.Check if the charge system is malfunction.


    7      P0110     Inlet air temperature           2       1. Check if the connector of Inlet air temperature
                     sensor or electric circuit              sensor loosen.
                                                             2.Check if the resistance of sensor is normal .
                     malfunction
    8      P0410     Idle air valve or electric      2       1. Check if the connector of Idle air valve
                     circuit malfunction                     loosen.
                                                             2.Check if the resistance of valve is normal.
    9      P0505     Idle speed volume               2       1.Check if the opening angle is over 180 for
                     control range                           Idle air valve.
                                                             2.Check if the opening angle is malfunction.
                         bl
    10     P0251     Injector or electric            2       1.Check if the connector of Injector is loosen.
                                                             2.Check if the ECU send signal to Injector.
                     circuit                                 3.Check if the power source and resistance of Injector are
                         bl                                  malfunction.




                                                                                                          14-8